Just a couple of suggestions please..

[Blue-Civic-Hybrid]

I am planning on installing a JSRC on my B18C1 this weekend, and I would just like a few suggestions. I am installing a Hondata heatsheild, but i noticed how thick this gasket is, it'a approxiamately 3.33mm thick, and I am just wondering if i will need to source some extended intake mainfold studs. I called ARP, but they do not make any for this motor. Does anyone have any install tips you could pass onto me? Thanks if you do, and /or suggestions... [img]graemlins/thumbs_up.gif[/img]

[klintman]

i was able to fit mine w/ the stock studs . i didnt use the the washers though . to be shure the nuts didnt resonate off the studs i used a little low strength locktite . ~10,000mi and ive had no issues w/ this setup .

[Blue-Civic-Hybrid]

So the hondata heat shield poses no problem right? I'm doing my install tomorrow and sunday..hopefully i get everything in in one day...

[gsrteggie]

I'll be doing mine in a month. Ask me then [img]tongue.gif[/img]